This pocket clip is only suited for HDS Systems EDC flashlights with click switch.
## Suited for:
[HDS Systems EDC Executive](/en/pt/-hds-systems-edc-executive-torch-250-lumen.htm)
[HDS Systems EDC LE](/en/pt/-hds-systems-edc-le-torch-250-lumen.htm)
## Installation instructions from HDS Systems:
Unscrew the switch cap and set the switch cap aside.
If the external O-ring was installed, remove it and set it aside. The external O-ring was visible prior to removing the switch cap and is visibly narrower than the internal O-ring.
The external O-ring is not used when the Clicky-style pocket clip is installed.
Remove the internal O-Ring and set it aside. The internal O-ring sits in a groove just past the threads. It is visibly fatter and slightly smaller in diameter than the optional external O-ring. Be careful not to damage this O-ring because it seals the switch cap.
Slide the pocket clip over the threads, past the groove and onto the narrow shelf just past the O-ring groove. You will need to hold the pocket clip in this position temporarily.
Replace the interior O-ring into its groove between the pocket clip and the threads.
Replace the switch cap. The switch cap can be tightened against the pocket clip to keep the pocket clip securely in one position.
The installation is now complete. You reverse the procedure to remove the Clicky-style pocket clip.
You may want to save the optional external O-ring if you later remove the pocket clip – to provide a nicer exterior appearance. However, the optional external O-ring is not necessary and may be thrown away.
HDS systems pocket clip for the click switch, bezel-down
$16.09 $10.62
SKU: KT0346
Category: Flashlights
Be the first to review “HDS systems pocket clip for the click switch, bezel-down” Cancel reply
You must be logged in to post a review.
Related products
Sale!
Sale!
Sale!
Flashlights
Sale!
Flashlights
Sale!
Flashlights
Sale!
Flashlights
Reviews
There are no reviews yet.